Show mirroring command

From NetworkCommands

A command available on most Extreme switch platforms; used to display port mirroring configuration and status information.

Usage Syntax

show mirroring

Typical Output

switch-one # show mirroring
Mirroring disabled

switch-one # show mirroring
Mirror port: 40 is down untagged
port number 31 in  all vlans

Related Commands

The configure mirroring command is used to specify a port or VLAN to mirror from (the source.)

The enable mirroring command is used to specify the mirror port, to mirror to (the destination.)

Command Equivalents

The Cisco command equivalent is the show monitor command

The F5 BigIP command equivalent is the bigpipe mirror show command

Related Articles

Information on other Extreme commands

Information on Linux commands

Information on F5 BigIP commands

Information on Cisco commands

Information on Vyatta commands

Information on Zebra commands

Information on Secure Platform commands

Information on Blue Coat SGOS commands

Information on Nokia IPSO commands

We really do appreciate all feedback so please do send your comments, suggestions or corrections to steve#networkstuff.eu (replacing the # with an @)