Show management command

From NetworkCommands

A command available on most Extreme switch platforms; used to display detailed information on management access and protocols, such as Telnet, SSH, SNMP and RMON.

Usage Syntax

show management

Typical Output

CLI idle timeouts:              enabled 20 min
CLI Paging:                     enabled
CLI Prompt Number:              enabled
CLI configuration logging:      enabled
Telnet access:                  disabled tcp port: 23
Web access:                     enabled tcp port: 80
Web HTTPS access:               cert key pair valid, enabled tcp port: 443
SSH Access:                     key valid, enabled tcp port: 22
UDP Echo Server:                disabled udp port: 7
SNMP Access:                    enabled(SNMPRO/None)
SNMP Read Only Communities:     xxxxx
Total Read Only Communities:    1
SNMP Read Write Communities:    None
SNMP dot1dTpFdbTable:           disabled
RMON polling:                   enabled
SNMP Traps:                     enabled
SNMP v1/v2c TrapReceivers:
   Destination            Community            Source IP Address  Flags
   188.16.135.77  /162    pub                  162.21.215.1      2EA
   188.16.7.35    /162    pub                  162.21.215.1      2EA
   11.16.7.96     /162    pub                  162.21.215.1      2EA
   11.20.135.113  /162    pub                  162.21.215.1      2EA

Flags:  Version: 1=v1 2=v2c
        Mode: S=Standard E=Enhanced
        Trap Groups: s=STP b=BGP o=OSPF p=Ping/Traceroute v=VRRP y=System
                     e=Extreme m=Smart Traps a=Auth l=Link Up/Down r=RMON
                     c=Security
                     A=All
SNMP MAC Security traps:        disabled
Link Up/Link Down traps enabled on ports:  All,   mgmt

SNMP stats:     inPkts 0        outPkts 0       errors 0        authErrors 0
                Gets 0          GetNexts 0      Sets 0
SNMP traps:     sent 1564       authTraps enabled

Exceed-committed-rate traps enabled on ports: None


Login stats:
        validLogins 47  badPasswords 0  unknownUsers 4(last bad user: siveson)
        Telnet: total 47        valid 47        invalid 0
        HTTPS:  total 0 valid 0 invalid 0
        HTTP:   total 0 valid 0 invalid 0

Management access stats:
        Protocol   UDP/TCP    Port       Total packets   Rejected packets
        SNMP-READ  UDP        161        0               0


        Protocol   Source IP Address    UDP/TCP    Port   Time
        --         --                   --         --     --

Command Equivalents

The closest Cisco command equivalent is the show run command

Related Articles

Information on other Extreme commands

Information on Linux commands

Information on F5 BigIP commands

Information on Cisco commands

Information on Vyatta commands

Information on Zebra commands

Information on Secure Platform commands

Information on Blue Coat SGOS commands

Information on Nokia IPSO commands

We really do appreciate all feedback so please do send your comments, suggestions or corrections to steve#networkstuff.eu (replacing the # with an @)