Show cpu-dos-protect command
From NetworkCommands
A command available on most Extreme switch platforms; used to display CPU DoS protection settings and statistics.
Contents |
Usage Syntax
show cpu-dos-protect [ports (x | x - x)]
Usage Examples
show cpu-dos-protect
show cpu-dos-protect ports 12 - 18
Usage Notes
If no port is specified, information for all ports is displayed.
Typical Output
show cpu-dos-protect
Note that the statistics display the remaining number of packets that can be processed by the CPU, not the number of packets that have been processed by the CPU.
Denial-of-service protection to CPU is ENABLED Notice level: 0 new packets/second (level for logging) Alert level: 0 new packets/second (level for ACL creation) Filter types: destination ACL timeout: 0 seconds ACL rule precedence: 0 Messages are OFF Trusted Ports: none ACL not active Cpu dos protect : enabled Port L3Miss L3Err Bcast IpUnkMcast Learn Curr Int Cfg Thr Cfg Int Pass ------------------------------------------------------------------------------- 1 150 150 150 150 150 1 150 1 0 2 150 150 150 150 150 1 150 1 0 3 150 150 150 150 150 1 150 1 0 4 150 150 150 150 150 1 150 1 0 [...remainder omitted...]
Related Commands
The configure cpu-dos-protect command is used to configure CPU DoS protection settings
Command Equivalents
The closest Cisco command (and feature) equivalent is the storm-control command
Related Articles
Information on Cisco commands 
Information on Vyatta commands 
Information on Extreme commands 
Information on Linux commands 
Information on F5 BigIP commands 
Information on Blue Coat SGOS commands
Information on Nokia IPSO commands
 We really do appreciate all feedback so please do send your comments, suggestions or corrections to steve#networkstuff.eu (replacing the # with an @)
|
