Enable mirroring command

From NetworkCommands

A CLI command available on most Extreme switch platforms; used to specify a port to output mirrored traffic to (the mirror port.) In other words, this command specifies the mirroring destination.

Usage Syntax

noinclude/noinclude enable mirroring to port port_number [tagged|untagged]

Usage Examples

enable mirroring to port 1:8 untagged - mirror traffic from the port or vlan specifed with the configure mirroring command (the source) to the specified port (the destination.)

Usage Notes

The configure mirroring command must first be used to specify the port(s) or vlan(s) to be mirrored 'from' (the source.)

The specified port must not be configured in a vlan if you specify untagged.

Annoyingly, the port must be active (up) when this command is entered.

Related Commands

The configure mirroring command is used to configure the port(s) or vlan(s) to be mirrored from.

The show mirroring command is used to display current port mirroring configuration and status.

Command Equivalents

The Cisco command equivalent is the monitor session command

The F5 BigIP command equivalent is the bigpipe mirror command

Related Articles

You may be interested in our Port Mirroring Masterclass article

Information on other Extreme commands

Information on Arista commands

Information on Cisco commands

Information on Vyatta commands

Information on Force10 commands

Information on Linux commands

Information on F5 BigIP commands

Information on Nortel commands

Information on Bluecat commands

Information on Zebra commands

Information on Windows commands

Information on Secure Platform commands

Information on Blue Coat SGOS commands

Information on Nokia IPSO commands

We really do appreciate all feedback so please do send your comments, suggestions or corrections to steve#networkstuff.eu (replacing the # with an @)