Dev command

From NetworkCommands

A command available on most Cisco platforms, in ROMmon (ROM Monitor Mode); used to list available file systems and devices.

Usage Syntax

dev

Typical Output

Device: Cisco 6500 Supervisor 720

rommon 1 > dev
Devices in device table:
        id  name
bootflash:  boot flash       
    disk0:  PCMCIA Disk 0    
    disk1:  PCMCIA Disk 1    
    eprom:  eprom

Related Commands

See the ROM Monitor Mode article for information on other commands available with this device management interface.

Related Articles

As ROM Monitor Mode is normally only used when performing password recovery or troubleshooting boot problems, you may find the Troubleshooting and Password Recovery article categories useful.

You may in ROM Monitor Mode due to a misconfigured configuration register value.

Information on other Cisco commands

Information on Vyatta commands

Information on Extreme commands

Information on Linux commands

Information on F5 BigIP commands

Information on Blue Coat SGOS commands

Information on Nokia IPSO commands

We really do appreciate all feedback so please do send your comments, suggestions or corrections to steve#networkstuff.eu (replacing the # with an @)